1. The aluminum composite panel should be stored or installed in a dry and ventilated place,avoid water accumulation, and the ambient temperature should not be higher than 70℃. Avoid installation in harsh environments such as smoke, dust, wind and sand, radiation, harmful gases, and chemical environments.
2. During transportation or storage, the aluminium composite panel must be laid flat. During the lifting process, you must lift the four sides of the panel at the same time. Do not drag the board on one side to avoid scratching the surface of the board.
3. When grooving, you should use a round head or a V-shaped flat-head saw blade or milling cutter of ≥90 degrees for grooving, and a 0.2-0.3mm thick plastic core board must be bent together with the panel to increase strength and toughness and prevent Aluminum flake hydrogenation. Too sharp corners or cutting damage to the aluminum panel or too thick plastic left will cause the aluminum panel to break or the paint film to burst during bending.
4. When bending the edge, use uniform force and do not bend repeatedly, otherwise the aluminum panel will be broken.
5. In order to maintain the flatness of the aluminum-plastic panel project and enhance its wind resistance, the aluminum-plastic panel needs to be lined with a skeleton and glued with the board after bending.
6. When used for curved surface decoration, do not make it in one step. The bending radius should be greater than 30cm. Use bending equipment to bend the aluminum-plastic panel, slowly and hard, so that the panel gradually reaches the required curved surface.
7. In order to avoid parallax, the aluminum composite panel should be installed on the same plane in the same process direction.
8. The protective film should be removed within 45 days after the aluminum-plastic panel is installed to prevent the protective film from aging. Otherwise, it may cause glue drop when tearing the film.
9. The aluminum composite panel without fluorocarbon coating should not be installed outdoors to ensure their service life.
10. If the surface of the board is contaminated during construction or use, it can be cleaned with neutral detergent. Do not use strong acid or strong alkaline detergent to clean it to damage the board surface.
